DecoPoxy is specifically formulated to protect commercial or residential concrete floors. It provides high gloss, abrasion and chemical resistance, and an easy-to-maintain finish, while bringing out the finished concrete color with full depth and no fading.
?What is concrete sealer
Sealers are a wide range of materials designed to protect the surface of concrete. Each sealer has its own capabilities and characteristics. Many seals are designed to protect against common food and chemical stains. Sealers are often used to control water penetration or protect against harmful salts. They may even resist wear or improve handling
:product introduction
This lining is designed based on epoxy resin and polyamide hardener and due to its low viscosity, it has the ability to penetrate the pores of concrete, stone, plaster and wood. With very high adhesion to the concrete surface, on the one hand, it increases the adhesion of the epoxy coating, and on the other hand, it prevents the penetration of moisture into the coating and prevents the coating from separating. This flexible lining does not undergo changes such as cracking and separation from the surface due to mechanical and thermal stresses.
:Surface preparation conditions
Before applying the desired surface coating, it must be completely dry and free of fat and oil, so that the necessary mechanical bond for adhesion to the surface is created, and the surfaces that are loose or porous can be easily separated from the work surface, and after emptying the contamination, all The surface dust is collected by a strong suction and a lining layer is applied on the surface by a hair roller. If there are many pores in concrete (especially fresh concrete), two lining steps are required.
:How to apply concrete sealer
Sealer is an important part of decorative concrete. The sealer is also the biggest source of technical problems and breakdowns. Most of the failures are caused by poor use of sealer. This is why the correct use of concrete sealer is very important. Choose the right sealer for the job and apply it properly. This prevents expensive breakdowns and repairs.
:Method of Use
Considering the importance of the mixing ratio of the components and its effect on the quality of the product, we mix the two components B and A together and stir for 5 minutes with a suitable mixer until it becomes uniform. Immerse the roller in the container and then move it on the work surface in different directions until the concrete surface is completely coated. A brush is used for June seam and concrete edges. In addition, you can use an airless device or a sprayer to spray the product.
:Usage time
The maximum application time after mixing the components is 8 hours.
:Performance tools and equipment
Scraper, hand mixer with suitable power, roller, brush
:Storage time
One year under standard conditions.
دیدگاه خود را بنویسید